1/2-inch MT2 Drill Chuck - Keyed with No 2 Morse Taper Arbor is great for holding drill bits, small turnings, dowels, pen mandrel shafts, and much more. #2 Morse taper for Delta and Jet lathe headstocks or tailstocks. A 1/2 inch grip can be used for grabbing small turnings or pen ...1/2-inch MT2 Drill Chuck - Keyed with No 2 Morse Taper Arbor is great for holding drill bits, small turnings, dowels, pen mandrel shafts, and much more.
#2 Morse taper for Delta and Jet lathe headstocks or tailstocks. A 1/2 inch grip can be used for grabbing small turnings or pen mandrels on the headstock or a drill bit in the tailstock.FeaturesIncludes the 1/2" Drill Chuck, #2 Morse Taper Arbor, and Jaw Tightening Key - This 3-Jaw Chuck will mount into the headstock or tailstock of any lathe that accepts #2MT accessories - The #2MT Arbor accepts 1/4" x 20tpi draw bolt; Draw bolt not included - Removes easily with knock out bar - Note: To use in the headstock, it must be used with a drawbolt. Draw bolts can only be used with lathes that have a through hole in the headstock.
They are threaded into the taper and are kept in place with a washer and nut on the back end of the headstock. Thread size is 1/4 x 20tpi or 6mm x 1.0.